MP Rotator Water Saving Lawn Sprinklers
Catalog Page 52, 54

We are very excited to finally be able to offer you this unique product. We have been following its development for 3 years and are more than satisfied with what we have seen. This is the perfect sprinkler for situations dealing with odd shaped areas or heavy soil conditions that cause water run-off with normal pop-up sprinklers.
Average precipitation is .4 inches per hour.

• Uses 65% less water than standard sprinklers in similar situations. Triples the area covered per zone.
• Saves money on valves and pipe sizing.
• An overall water savings of up to 30% (you will need to water longer)
• Adjustable arc (except full circle) and radius for difficult shapes and sizes.
• Matched precipitation rate for all sprinklers - even after radius and angle reduction.
• Works with most pop-up sprinklers (see POPUP4 below) or stakes and solid risers with adapter
• Four different angles available.
• Filter screen included with each sprinkler.
• Pressure Range: 25-55 PSI

• Molded, pressure activated wiper seal stops leakage around the popup assembly
• Stainless steel return spring
• Constructed of UV resistant plastic for long life
• Operating range: 15-70 PSI
• Nozzles for 4' to 17' radius available (PONOZ4, PONOZ7, PONOZ10, PONOZ12, PONOZ15, PONOZ17)
• Also works with MP Rotator Sprinklers above
• Easy to remove top
• Complete with filter screen
• 1/2" Female Pipe thread inlet
• Spray top threads are compatible with most brands of nozzles
• Nozzles adjustable from 30° to 360°
• Note that POPUP4 does not come with a nozzle. Select one from below

A great way to adjust your sprinkler head height by hand. Without the use of tools, loosen the slip joint nut and adjust the sprinkler head to the desired height. Then retighten the slip joint nut. Always have the sprinkler head open to prevent water pressure build up.
Adjust from 12" to 23".
1/2" MPT x 1/2" MPT

A swing joint has flexible fittings built into it that absorb shock exerted on the sprinkler.   They also make it easy to adjust the proper height, angle and placement for the sprinkler.

This plastic stake has a 1/2" EasyLoc fitting on the side and a 1/2" MPT base on the top. It allows you to easily use 1/2" poly tubing with a Popup 4 sprinkler or any other fitting on a 1/2" MPT base. With a 1/2" FPT coupler the stake can be use with an Adjustable Gear Drive sprinkler which has a 1/2" MPT base.

This plastic stake has 1/2" EasyLoc fittings on each side and a 1/2" MPT base on the top. It allows you to easily use 1/2" poly tubing inline with a Popup 4 sprinkler or any other fitting on a 1/2" MPT base. With a 1/2" FPT coupler the stake can be use with an Adjustable Gear Drive sprinkler which has a 1/2" MPT base.