1/2" Compression End
These compression ended fittings come in either an
elbow or a tee and adapt directly from a 1/2" riser
to drip tubing.
When using these fittings, the water must be either
pre-filtered or use a special 100 mesh stainless steel
cone shaped screen washer.
|
|
| |
1/2" FPT to Male Hose Elbow
NEW!!
The MHT outlet on the hose shut-off will adapt an existing riser to a
drip system. Attach an ELFH (pg 31) or CHS (pg 32) to the outlet end
and, if necessary, a hose threaded filter.
|
|
| |
1/4" Barbed End Fittings
These parts are for going directly form a 1/2" riser
to 1/4" tubing so the amount of water they can provide
is quite limited.
They are all designed for use with pre filtered
water or a cone screen washer.
|
|
| |
Threaded Sprinkler Adapter
Use this with any of our sprinklers or sprayers
with 10/32nd or 10/24th threaded base.
|
|
| |
2-Way 1/4" Manifold
NEW!!
This swivel manifold adapts a 1/2" riser to one or tow 1/4" lines.
Screen washer included.
|
|
RB2M
|
| 1-39 | $1.60 | Each |
| 40+ | $1.44 | Each |
| |
|
8-Way Adjustable1/4" Manifold
NEW!!
Each outlet on this 8-way manifold has an adjustable flow control.
|
|
|
R8WADJ
|
8-Way 1/4in Manifold
|
| |
Press Fit Adapter
Special Ein Dor press fit base for use with all
Ein Dor Mini-Sprinkler heads or Wing Sprinklers.
|
|
|
ME12B
|
Press Fit Adapter, 1/2in FPT
|
| |
Accessories
|
|
Cone Screen Washer
This washer slips into 1/2" PVC fittings or Cut Off
risers and is specially designed for drip irrigation systems.
|
|
| |
Cut Off Riser
A 1/2" threaded nipple which can be cut to any
length from 2 1/2" to 5".
Male pipe thread on both ends.
|
|
| |
Hose Cap
Hose cap with washer.
|
|
| |
Screen Washer
A very fine mesh screen for inserting into any female hose
beginning for systems that have city water or very clean wells.
|
|
| |
Threaded Caps for unused Risers
|
|
| |
| |
Water Whiz Adjust-A-Riser
NEW!!
Adjust the height of your shrub sprinkler as your plant grows!
A great way to adjust your sprinkler head height by hand.
Without the use of tools, loosen the slip joint nut and
adjust the sprinkler head to the desired height.
Then retighten the slip joint nut.
Always have the sprinkler head open to prevent water pressure build up.
Adjust from 12" to 23".
1/2" MPT x 1/2" MPT
|
|
|
PGADJR
|
Water Whiz Adjust-a-Riser
|
| |
Emitters 
Checkout 
Call 
